Install Instructions

Installation
Installation in general
Warning!
Safety valves must be installed according to pres sure
vessel regulations.
Note!
Before connecting an y piping, make sure a ll foreign
objects have been flushed out of the system.
The installation m ust be installed with equipment that protects
it against pressures and temperatures outside the ap proved
minimum a nd maximum values shown on the name plate.
For vibration risks, ins tall anti-vibration m ountings as shown in
picture for rigid pipe system in s ection M ounting at page 15.
Normally the plate heat exchanger is connected so that the
media flows through the plate heat exchanger in opposite
directions (in counter-current flow) and in most cases this
provides the best heat transfer performance.
S4 S1
S3 S2
Take into account the risk of fire during installation, i.e. bear in
mind the distance from flammable substances.
Connections
Threaded conn ections – U se a torque wrench when
connecting the pipe and observe the specified limits. Refer to
table on page 14.
Brazed co
nnec tions – Clean by rubbing down and degreasing
the various s urfaces. Use the correct brazing temperature and
brazing metal grade.
Document ID Language Edition
16
Instruction M anual -
Brazed plate heat exchangers
3450021401 EN 2017-06