user manual

17
WARNING: Follow the instructions before turning on the oven.
- Check all gas connections for gas leak before starting your oven.
- Use the proper PTFE gas piping tape for all threaded connections
- Do not lean over the oven when lighting. Keep your face and body at a safe distance from the
oven door.
- When lighting the oven, the oven door must be open.
- The burner control knob must be in the off position before turning on the LGP cylinder valve.
- Do not move the oven while it is in use.
- STEP 1 - Push IN the burner knob and turn it
counterclockwise to the star symbol on the control
panel, to ignite pilot ame.
- STEP 2 - While KEEPING the burner knob pushed in,
push the ignitor button at the same time to light the
burner pilot ame.
NOTE: Lighting the pilot ame for the rst time or
after it has cooled could take a few attempts due to
air in the supply line. Be patient.
- STEP 3 - Once the pilot ame is lit properly you
will see a small ame inside (rear left corner) the
oven. You can then release the ignition button BUT
will need to KEEP the burner knob pushed in for 15
seconds. This will insure that the thermocouple is hot
enough to allow the pilot ame to stay on.
- STEP 4 - Release the burner knob and turn it
counter- clockwise to the larger dual ame symbol
on the control panel. The oven burner is now on high
and you can start preheating the oven.
FOR YOUR SAFETY:
- Do not close the door when the oven is lit with the ame at the maximum position.
- Do not exceed the temperature limit of 500°C / 1000°F.
- Never disconnect the gas pipe or other ttings when using the oven.
OVEN USE
ONLY FOR GAS VERSION