User Manual

The Syntax Error
2
includes a versatile and powerful mini-sequencer, which can control any one of the
pedal knobs. This enables you to create animated textures, arpeggios, LFO eects, and more.
To enter the sequencer control mode, tap the MODE button until the page label reads SEQ.
The A B X Y knobs will directly control the values of each sequencer step, so that you can dial in or
tweak the sequence at any time. The value of each step is shown by the boxes on the display bars, and
the current step is indicated by the lled box.
Use the MODE knob to highlight one of the other sequencer parameters, then turn the MIX / DATA
knob to set that value.
MINI-SEQUENCER
SPACE 24
SEQ-> FEED
SEQ
GLIDE 3
TRIG TOGG
PATT ---
RATE 511
MIX
(DATA)
MODE
PRESS PAGE
HOLD MENU
STEP A
VALUE
STEP B
VALUE
STEP C
VALUE
STEP D
VALUE
RATE: Sets the sequencer step speed, higher numbers are faster.
GLIDE: Sets the smoothness of the sequencer steps. At very low settings the sequencer will
glide for a long time and may not reach the nal step values.
SPACE: Sets the muting or staccato eect between sequence steps. At low settings the output
will be very choppy, at high settings no muting will occur.
TRIG: Sets the sequencer trigger mode for the CONTROL footswitch.
STEP: Tap the CONTROL switch to manually select each step
ONE: Tap the CONTROL switch to run the sequence one time and then return to
normal settings.
MOM: Hold the CONTROL footswitch to run the sequencer, release to stop the
sequence and return to normal.
TOGG: Tap the CONTROL footswitch once to start the sequence, tap again to stop. If
the TRIG mode is set to TOGG, the pedal will save the sequencer on / o state and load it
as part of the preset.
SEQ->: Sets the pedal knob for the sequencer to control. All knobs are available.
PATT: Selects from 8 built-in sequencer patterns, or turn the A B X Y knobs to
create your own pattern.