User Manual

EXPRESSION PEDAL
The Syntax Error
2
will smoothly blend between the two knob settings as you move the
expression pedal. You can map any of the MAIN or ALT controls to the pedal.
If you prefer to have controls that aren’t affected by the expression pedal, simply set
them with the pedal heel down, then gently “wiggle” the knob with the pedal at toe
down. This will set the same values for heel and toe and those knobs won’t change as
you sweep the pedal.
Note: sequencer settings aren’t mappable to the expression pedal.
The MultiJack input is factory-calibrated for most common expression pedal types,
but you can also adjust the range using the conguration menu. Tweak the EXP LO
parameter to set the heel down value and the EXP HI parameter to calibrate the toe
down position.
Connect a TRS expression pedal to the MultiJack to control any or all of the pedal
parameters remotely.
The Syntax Error
2
requires a TRS expression pedal, sleeve = 0V (common,) ring =
3.3V, tip = 0-3.3V. You can also use an external control voltage connected to tip and
sleeve, as long as it doesn’t exceed 3.3V.
If you’re using a MIDI controller, you can send MIDI CC 100, value 0-127. 0 is the
same as full heel setting, 127 is toe setting.
To map expression pedal values to pedal settings, rst set the expression pedal to the
heel setting then turn the pedal knobs. Then sweep the expression pedal to the toe
setting and turn the knobs again.
1 SYNTAX 2
SAMP PLAY
SIZE FEED
MIXMAINSTRETCH
EXP
1 SYNTAX 2
SAMP PLAY
SIZE FEED
MIXMAINSTRETCH
EXP
HEEL SETTING TOE SETTING