User Manual

14
SPECIFICATIONS
• Input: Mono or stereo (TRS)
• Output: Mono or stereo (use either TRS or dual TS)
• Input Impedance: 1M ohms
• Output Impedance: 560 ohms
• Power Requirements: DC 9V only, 250mA or greater
• Requires isolated DC power supply
• Dimensions: 2.4” x 4.7” x 1.6” W x H x D not including knobs (67 x 120 x 42mm)
• 32 user presets, selectable on-device without additional controllers
• MultiJack enables expression pedal, foot switch, expander switch, or MIDI input
• Full MIDI control over every knob and setting
• EXP Morph allows controlling all knobs from expression or MIDI
• Automated ramping function for expression without external pedal
• CTL foot switch for tap tempo or ramp trigger
• USB port for rmware updates and USB MIDI
• Buered bypass (hybrid analog+digital)
CHANGE LOG
Manual version 1.00d, rmware version 1.0d
v1.00d 2/23/22
DYNAMIC mode now shows when envelope detector is bypassed
DYNAMIC mode now has DUCK option, decreases wet level when signal is present
Fix issue with tap divisions going away during ramps / expression
Fix issue with tap tempo changing expression settings for the worse
v1.00c
Ramp always resets after program load, ramp also clears if trigger mode is changed
Increased reverse bit crush bypass level, should bypass at lowest knob settings
Fix DUAL mode bar for time2 not being drawn correctly
v1.00b
Added ms / bpm time display to delay 2 of DUAL mode
Added dual bank (1-16 or 17-32)
Now shows RAMP bar even if EXT CLOCK is present
Change low-cut values for TAPE mode, set AGE to minimum for max low end
v1.00a
Added time display options
removed time display from tap bar display cong
GREAT TONES. DOING GOOD.