User Manual

12 13
MIDI SETUP
The MultiJack can also act as a MIDI interface, to allow full remote control of your Leap Series
pedal.
Enter the Setup menu and congure M.JACK = MIDI, then set CHANNL = your desired MIDI
channel. Save and exit.
You can then connect your Leap Series pedal to your MIDI controller or other device using
the MultiJack.
We recommend the use of an active MIDI converter such as the Disaster Area MIDI Box 4.
MIDI THR UM IDI I N9V DC
MIDI BOX 4
PWR / MIDI
TIP ACTIVE ALEXANDER, MERIS, EMPRESS TIP AND RING ACTIVE USE TRS Y-CABLE
TRS MIDI BOSS, JACKSON, COOPER RING ACTIVE CHASE BLISS AUDIO
RH R T RH R T RH R T RH R T
DOT MATRIX DISPLAY
BYPASS
PRESET
TAP
CTRL
PAGE
MENU
SERIES
R
L
MULTI
IN
FROM MIDI
CONTROLLER
TRS OR MONO
CABLE
SET TIP ACTIVE
(ALEXANDER)
CONFIGURE
JACK=MIDI
The MultiJack is also compatible with many devices using a passive MIDI to TRS cable.
We recommend the Disaster Area 5P-TRS PRO but most TRS type-A cables should work so
long as pin 2 is earthed at the MIDI controller output. Please note that some MIDI controllers
do not support the use of a passive MIDI to TRS cable, consult your controller manufacturer.
The MultiJack is wired using Tip = Current Sink, Sleeve = Ground / Common.
NOTE: In some cases, MIDI interference can occur if the TRS ring is left oating. We
recommend you set MIDOUT to OFF or USB, this disables the ring connection and will
prevent MIDI echoes.
MIDI COMMANDS
Your Leap Series pedal features full and comprehensive MIDI implementation. Every single
function and knob may be controlled by MIDI.
Each MIDI command controls the knob or function as described below. Please consult the
Sound Modes (page 4-5) section to match each knob position to the relevant control.
Leap Series pedals will sync to incoming MIDI clock messages for any modes that have the
DIV knob on the last page of the display. The pedal will subdivide incoming clock as set by
DIV, or set DIV to NCLK to force the pedal to ignore incoming clock. This setting is saved per-
preset. Please consult the Tap Tempo and MIDI Clock section on page10 for details.
Command MIDI CC Range
Knob 0 (PG1 upper L)
50 0-127
Knob 1 (PG1 upper R)
51 0-127
Knob 2 (PG1 lower L)
52 0-127
Knob 4 (PG2 upper L)
54 0-127
Knob 5 (PG2 upper R)
55 0-127
Knob 6 (PG2 lower L)
56 0-127
Knob 7 (PG2 lower R)
57 0-127
Knob 8 (PG3 upper L)
58 0-127
Ramp Rate
59 0-127
Level
60 0-127
Ramp Trigger Mode
61 0-50 TOGG
51-110 MOM
111-127 CLR*
Command MIDI CC Range
SOUND MODE
53 0-12 TAPE
13-25 ANALOG
26-37 DIGITAL
38-50 PITCH
51-63 DUAL
64-75 DIFFUSE
76-88 REVERSE
89-101 DYNAMIC
102-113 FILTER
114-127 LO-FI
TAP TEMPO
93 ANY
RAMP TRIGGER 97 ANY
EXPRESSION PDL
100 0 HEEL, 127 TOE
BYPASS
102 0 BYP, 127 ON
MIDI BEAT CLOCK
CONTROLS
DELAY TIME
DETAILS ON PG 10