User Manual

2 3
INPUT: Instrument input. Defaults to mono, may be set to TRS Stereo or TRS Sum using
the Setup menu.
RIGHT: Right stereo output. This output may be phase-inverted in the Setup menu to
match the output phase of your ampliers.
LEFT / TRS: Main output. Use this as the main output for mono setups, or the left output for
stereo. May also be used as a TRS stereo output (disables the RIGHT jack) if the
next effect or input is TRS stereo.
MULTI: User congurable jack, used for Expression pedal (TRS only,) remote foot switch,
or MIDI input / output (requires converter unit or adapter cable.)
DC 9V: Center-negative, 2.1mm ID barrel jack for DC input. The pedal requires a
minimum of 250mA to operate, higher current supplies are acceptable. Do not
power the pedal from a source greater than 9.6V DC.
USB: USB mini-B connector for USB MIDI or rmware updates
INS & OUTS
INPUT
MONO OR TRS
STEREO INPUT
RIGHT
R STEREO OUTPUT
LEFT
MONO OUTPUT
OR TRS STEREO
MULTI
EXPRESSION
PEDAL OR MIDI
R
L IN
CTRL
PAGEPAGE
MENU
MENU
PAGE
MENU
We’ve equipped every Leap Series pedal with a plethora of pluggable ports, to allow you lots of
exibility in your pedalboard routing.
We’ll cover the stereo routing stuff in full detail on page 10, but if you’re running in mono just
use the input and L output jacks.
BYPASS & TRAILS
Leap Series pedals feature a buffered bypass system designed to keep your signal as clean
as possible at all times. The dry signal passes through the digital signal processor in order to
maintain phase coherence between wet and dry.
We offer three bypass modes, selectable with the TRAILS item in the Setup menu.
OFF: The wet signal is cut off immediately upon entering bypass
ON: The wet signal delay / reverb trails are allowed to ring out in bypass
AUTO: The wet signal delay / reverb trails are allowed to ring out but automatically
fade out after 10 seconds to eliminate noise in bypass
CONTROLS & DISPLAY
Your Leap Series pedal is pretty complex under the hood, but we worked hard to make sure that
it’s easy to drive.
We combined a simple user interface with a high-contrast OLED display to get you the
maximum tweakability with the minimum frustration. Just turn the knobs, it acts like pretty much
every other pedal.
The lower right knob is equipped with push switch. Tap this knob to switch the display page, as
indicated by the three small boxes at the bottom of the display. We’ll refer to this knob + button
as the Page knob throughout this manual.
Hold the Page knob to access the Setup (page 7) and Preset Save (page 6) menus.
KNOB DISPLAY
Turn the pedal knobs to show the Knob Display.
Each knob is labeled with its function and current
value.
Set DISPLAY = KNOBS in the Setup menu to make
the pedal show this screen by default.
PRESET DISPLAY
Hold the Bypass / Preset foot switch to load a the
next preset and show this display. The current preset
name, number, and sound mode are shown.
Set DISPLAY = PRESET in the Setup menu to make
the pedal show this screen by default.
BYPASS | PRESETTAP | CTRL
SERIESSERIESSERIES
R
L IN
CTRL
DOT MATRIX DISPLAY DOT MATRIX DISPLAY DOT MATRIX DISPLAY
PAGEPAGE
MENU
MENU
PAGE
MENU
DISPLAY BLANK
Set DISPLAY = BLANK in the Setup menu to blank
the display. The display automatically returns to
Knobs or Preset mode when a knob is turned or a
preset is loaded.
. . .
HOLD BOTH FOOTSWITCHES
FOR PREVIOUS PRESET
HOLD RIGHT FOOTSWITCH
FOR NEXT PRESET