SDS

Page 3 of 5
Date:11.Jul.2015 No.:JST20150711010S
.Small Spill: Use appropriate tools to put the spilled solid in a convenient waste disposal container. Finish cleaning by
spreading water on the contaminated surface and dispose of according to local and regional authority requirements.
.Large Spill: Use a shovel to put the material into a convenient waste disposal container. Finish cleaning by spreading water
on the contaminated surface and allow to evacuate through the sanitary system. Be careful that the product is not present at a
concentration level above TLV. Check TLV on the SDS and with local authorities.
7 Handling and storage
.Handling:Handling of products may form nuisance dust. Protect personnel.
Pneumatic material handling and processing equipment may generate dust of sufficiently small particle size that, Pollution in
the surrounding air. Dust accumulations should be controlled through a comprehensive dust control program that includes,
but is not limited to, source capture, inspection and repair of leaking equipment, routine housekeeping and employee training
in hazards. See NFPA 654.
.Storage: Keep container dry. Keep in a cool place. Ground all equipment containing material.
Co
mbustible materials should be stored away from extreme heat and away from Alcohol, strong acid,strong oxidizing agents.
8 Exposure controls/personal protection
.Ventilation and Engineering controls: No special ventilation and engineering controls are required for handling.
.Respiratory Protection:No special respiratory protection is required for use of these products. If respiratory protection is
needed, use only protection authorized in the U.S. Federal OSHS Standard, applicable U.S. State regulations, or the
Canadian CSA standard.
.Body Protection: No special protective clothing is required.
.Protective Gloves: Rubber or plastic gloves with elbow-length gauntlet.
.Eye Protection: Unnecessary ,When necessary wear chemical goggles or face shield.
9 Physical and chemical properties
.General Information
For
m: Solid
Color: Black
Odor: Odorless
.Change in condition
Melting point/Melting range: Above 3600
℃
Boiling point/Boiling range: Above 4200
℃
.Ignition Temperature: Not available
.Density:
.Relative density: >1 (water=1)
.Vapor density: Not available
.Evaporation rate Not available
.So
lubility in/Miscibility with
Water: Insoluble
.PH-Value: Not available
Ningbo Jeston Certification Services Co.,Ltd. TEL:[phone] FAX: [phone]
宁波市朝晖路 416 弄 262 号综合楼 1105 邮编:315040 E-mail:[e-mail] www.nbjeston.com