Specifications

Hooking It Up
Studio 32 Reference Manual 32
Stereo Aux Returns
The STEREO AUX RETURNS are eight balanced 1/4" line input jacks that are most
often used to connect to the stereo outputs of four external effect units. However,
these may also be used as additional inputs for stereo sound modules, samplers or
synthesizers, if desired.
Monitor and Auxiliary Outputs
The MONITOR and AUXILIARY OUTPUTS are six balanced 1/4" jacks which feed
the signals from Monitor 1/2 and Aux 3-6. MON 1 and 2 are pre-fader, and are ideal
for feeding a headphone amp for musicians in the studio to monitor themselves and
other tracks already recorded onto tape. However, depending on your studio
hookup, you may find it more flexible to connect headphones to the jacks on the top
panel, which may be switched to receive the MONITOR 1/2 signal or the Control
Room mix. Aux 3 - 6 are post-fader, and are normally connected to the inputs of
outboard effects devices, like reverbs and digital delays.
Headphones
The headphone connectors (found on the upper right side of the console) are stereo
1/4" jacks which can drive most headphones. The signal level is controlled by the
PHONES knob. The wiring scheme is shown below; most headphones label which
side is left and right.
Tip
Ring
Sleeve
Left Signal
Right Signal
Ground
Tip
Ring
Sleeve
Headphones
Tip
Ring
Sleeve