Specifications

Hooking It Up
Studio 32 Reference Manual 25
CHAPTER 3:
HOOKING IT UP
Unpacking and Inspection
Your Studio 32 was packed carefully at the factory, and the container was designed
to protect the unit during shipping. Please retain this container in the highly
unlikely event that you need to return the Studio 32 for servicing.
Upon receiving the Studio 32, carefully examine the shipping carton and its
contents for any sign of physical damage that may have occurred in transit. If you
detect any damage, do not destroy any of the packing material or the carton, and
immediately notify the carrier of a possible claim for damage. Damage claims
must be made by you. Contact your Alesis dealer.
The shipping carton should contain the following items:
• This instruction manual and a quick reference sheet
• Alesis Studio 32 with the same serial number as shown on shipping carton
• A pair of rack rails with screws to mount them to the side panels
• AC Power Cable
• Alesis warranty card and other literature
✪ It is important to register your purchase; if you have not already filled out your
warranty card and mailed it back to Alesis, please take the time to do so now.
Installing in a Rack
The Studio 32 may be simply set on a table, or installed in a standard 19” audio
equipment rack. To rack mount the Studio 32, simply attach the provided rack ears
to each side using the screws provided. If you wish to save rack space, you may
remove the hand rest below the faders:
1. Remove the screw holding the plastic end caps to the sides of the hand rest.
Remove the end caps.
2. Remove the four screws attaching the hand rest to the front panel.
✪ Make sure you leave enough space at the top of any rack installation for the cables
which must be plugged into the back panel. By using right-angle plugs, this may be
kept to a single rack space if needed.