User Manual
    Glossary 
53 
Here are the definitions to some terms you’ll probably encounter 
while using your MultiMix USB2.0. 
Te rm    Definition 
ASIO      Audio Stream Input/Output. An audio protocol developed by Steinberg 
and used by multiple audio software manufacturers. 
aux (auxiliary)      An additional set of outputs and inputs found on many mixers. These 
allow the addition of external effects and other audio sources. 
balance      A control that lets you control the position of  sound in a stereo signal by 
altering the relative levels of  the left and right channels. 
bus      The electrical component that carries signals from multiple sources to a 
single destination such as an amplifier. 
channel      A path through which an audio signal flows. 
channel strip      A section of  a mixer on which reside controls like a fader, EQ and pan 
for manipulating the signal of  an input channel. 
clipping      The cutting of  an audio signal caused by a level that is too great for a 
mixer circuit to handle. 
codec   Compression/decompression algorithm. Different CODECs are used 
by different digital audio devices and file formats. 
condenser 
microphone 
    A type of  high-quality microphone that produces a weak signal, usually 
requiring an external power source like the ones provided by your 
MultiMix’s XLR mic inputs. 
DAW      Digital audio workstation. DAWs can be either standalone, like the Akai 
DPS series, or software. 
dB (decibel)      A common unit of  measure for audio. 
detent      A point of  resistance in the path that a mixer knob or fader travels. 
Detents are used to mark important settings. As you turn the knob or 
slide the fader, you’ll feel it “click” into the detent. 
dry      Term used to describe an audio signal free of  effects. The opposite of  
“wet.” 
dynamic 
microphone 
    A common type of  microphone that does not require external power. 
Dynamic microphones are generally cheaper than condenser 
microphones. 
effects processor      A unit whose purpose is to provide effects for audio signals. Some 
common effects include reverb, chorus, flange and delay. Effects 
processors come in many shapes and sizes, from small pedals up to 










