Specifications

REAL TIME MIDI SEQUENCING
27
SECTION 5
OPERATION
DATADISK is easy to operate. First, the desired function is selected
by pressing the appropriate function button; then, if necessary, the
desired page is selected by pressing the same function button
again. A file or parameter is then selected by pressing the SCROLL
UP or SCROLL DOWN buttons. The operation is then initiated by
pressing the DO/YES button. DATADISK will tell you what it is doing
and then prompt you when the operation is complete.
The following is a complete description of the steps used to
achieve each function:
TO FORMAT A DISK
1) Insert a disk into the disk drive.
2) Press the FORMAT button on the front panel. The display
will read:
FORMAT DISK?
3) Press the DO/YES button. The display will then read:
ARE YOU SURE?
Since formatting erases any information that may have
been previously stored on the disk, this page allows you
to rethink your decision. Pressing any other function
button than DO/YES will exit the Format page or prevent
initiating the formatting.
4) Press the DO/YES button a second time to start format-
ting. DATADISK will begin formatting the disk and the
display will read: