Manual
Table Of Contents
9
o Head-Rim Adj: The amount of crosstalk reduction between the head (center)
and rim of a drum pad. Higher values reduce the probability that the pad’s rim
sound will be triggered when you play its head only and vice versa (due to the
force being transferred through the pad). Don’t set this value too high, though! If
this value is too high, you may not be able to trigger its sound if you intentionally
play both the head and rim at the same time; it may be silenced because the
module incorrectly interprets the hit as crosstalk.
o Threshold: The amount of force required to trigger the sound.
o Xtalk: The amount of crosstalk reduction. Higher values reduce the probability
that the pad’s sound will be triggered when you play another pad (due to the
force being transferred through a rack, through the floor, etc.). Don’t set this
value too high, though! If this value is too high, you may not be able to trigger its
sound if you play another pad at the same time; it may be silenced because the
module incorrectly interprets the hit as crosstalk.
o Curve: The velocity curve of the pad. This controls the relationship between the
amount of playing force and the volume level of the pad’s sound.
o Retrig Cancel: The required amount of time between successive hits of the pad
to produce the sound for both hits.
o MIDI Note: When the drum module’s USB MIDI port or MIDI Out is connected to
a computer or external MIDI device, the pad will send this MIDI note to it. If you are
not using those connections, this setting will not affect the trigger or its sound.
Kick Drum 36 Tom 3 (Center) 43 Crash 1 49
Snare Drum (Center) 38 Tom 3 (Rim) 58 Crash 1 (Edge) 55
Snare Rim 40 Tom 4 (Center) 41 Crash 2 57
Tom 1 (Center) 48 Tom 4 (Rim) 39 Crash 2 (Edge) 52
Tom 1 (Rim) 50 Ride Bow 51 Hi-Hat Open 46
Tom 2 (Center) 45 Ride Edge 59 Hi-Hat Closed 42
Tom 2 (Rim) 47 Ride Bell 53 Hi-Hat Pedal 44
Hi-Hat Splash 21
o Splash Sens: The sensitivity of the hi-hat pedal to create a “splash” sound
rather than the usual “closed pedal” sound.
• To edit the parameter’s setting or value, use the dial or Left () and Right () buttons.
6. To save your changes, press Save. Otherwise, your changes will be lost when you power
off the drum module.
7. Press Exit to return to the previous page.