Specifications

35
Source = ADAT
Destination = S/PDIF
Destination Rate = 48kHz
Figure 10
Note: Even when the AI-1’s destination is set to S/PDIF, the digital
bus being received from the last ADAT is routed through back to
the first ADAT. Therefore, it is possible to bounce audio from the
last ADAT back to the first ADAT, while simultaneously routing
two tracks from the last ADAT to an S/PDIF device.
3.3G S/PDIF to ADAT (48kHz)
In this configuration, the ADAT optic jacks and the S/PDIF jacks are
used. In the figure below, ADAT #1 is receiving from an S/PDIF
device using a 48kHz sampling rate. The proper control settings for
this operation are as follows:
Source = S/PDIF
Destination = ADAT
Destination Rate = 48kHz
Figure 11