Specifications

34
3.3E AES/EBU to ADAT (44.1kHz)
In this configuration, the ADAT optic jacks and the AES/EBU XLR
jacks are used. In the figure below, ADAT #1 is receiving from an
AES/EBU device using a 44.1kHz sampling rate without
conversion. The proper control settings for this operation are as
follows:
Source = AES/EBU
Destination = ADAT
Destination Rate = 44.1kHz
Figure 9
3.3F ADAT to S/PDIF (48kHz)
In this configuration, the ADAT optic jacks and the S/PDIF jacks are
used. In the figure below, ADAT #2 is transmitting to an S/PDIF
device using a 48kHz sampling rate. The proper control settings for
this operation are as follows: