User guide

www.aleratec.com

Using the DVD/CD Duplicator

Using the Duplicator as a DVD/CD-Recorder - continued

Connect the USB 2.0 Data Cable to the Duplicator. ▪

Align and gently insert the USB 2.0 Data Cable into an available USB

2.0 port on your computer, making sure you do not bend the connector.

For P/N 260147 and 260148 and systems running Windows 98SE only: ▪

Install the USB 2.0 Drivers.

If you are running Windows 98SE: After your computer starts up, insert

the USB 2.0 Driver Software in your computer’s DVD/CD-ROM drive,

and run the driver install program to complete your installation.

Note: This step is not needed if you are not running Windows 98SE.

Go to Adv Setup step 13 and switch to USB Mode. Your computer should 2.

recognize the DVD/CD-Recorder in the DVD/CD Duplicator.

Install the software from the included CD.3.