User Manual

Page 1/2 Rev. 08/29/12 curves / CVRL TID

Curv radial lens

Technical Installation Data

without notice. 701 Millennium Blvd. Greenville, SC 29607 / Tel 864.678.1000 / Website www.aleralighting.com

Row Mounting

sections

BottoM View

data chaRt

Nominal

Length

Approx. Weight

A B C D

1-lamp 2-lamp 3-lamp

4' 13.3 lbs. 15.6 lbs. 17.9 lbs. 47 ¼" 48" 192 ⅝" 48 ⅝"

8' 25.3 lbs. 27.6 lbs. 29.9 lbs. 95 ¼" 96" 384 ⅝" 96 ⅝"

single Mounting

Connection SectionCross Section

2½"

9½"

4', 8'

A B B B

Note: Suspension data is computed using the standard aircraft cable assembly. The use of rigid stems will yield dierent data. Please consult

factory for stem data.

4', 8'

PAGE 1
Curv Radial lens Technical Installation Data sections 21/2" 91/2" Cross Section Connection Section Bottom View 8' Single Mounting D A 4', 8' Row Mounting C A B B B 4', 8' data chart Nominal Length Approx. Weight 1-lamp 2-lamp 4' 13.3 lbs. 15.6 lbs. 8' 25.3 lbs. 27.6 lbs. A B 17.9 lbs. 47 1/4" 29.9 lbs. 95 1/4" 3-lamp C D 48" 192 5/8" 48 5/8" 96" 384 5/8" 96 5/8" Note: Suspension data is computed using the standard aircraft cable assembly.
PAGE 2
Curv Radial lens Technical Installation Data Connection Instructions (2 Lamp): Suspension Instructions (2 Lamp): 1. Install first fixture of row with two hangers. 1. Set bottom nut to desired fixture height. 2. Slide inner die cast plates together. 2. Adjust upper nut for a minimum of 3/8" between upper and lower nuts. 3. Secure fixture joints with two bolts and nuts and attach hanger at opposite end. 4. Repeat steps 2 and 3 until row is complete. 3. Slide cable hanger into hanger slot. 4.