Owner`s manual

6 WATER TANK DRAINAGE
- Install the Flexible Exhaust Hose and the Adjustable Window Slider Kit .
- When the water level inside the internal tank reaches a predetermined level, the unit stop operation
automatically. The fan motor will continue to operate.
- Carefully remove the water tank from the cabinet and dispose of the water. Replace the water tank
back to its original position.
B) During Dehumidifying Mode:
- Remove the drain plug from the back of the unit and connect the drain hose, then connect the
other end of the drain hose to the water tank as depicted in Fig.5. So the condensed water will flow
into the internal tank through the drain hose.
- When the water tank is full, just pull it out and dispose of the water.
A) During Cooling Mode:
Remove the drain plug
from the back.
Remove the drain
plug and install the
drain hose.
Fig.5
7 CONTINUOUS DRAINAGE
- This unit also has provisions for a continuous drain option.
- During Cooling and dehumidifying modes, remove the drain plug from the back of the unit, then
install the drain hose , attach a section garden hose (not included) to the drain hose connector.
Place the open end of the hose directly over the drain area in your basement floor.
Please refer to Fig.6 & 6a.
Connect the
drain hose
Fig.6
Remove the
drain plug
Fig.6a
7
Note: This drain method will reduce the cooling capacity, in order to maintain the best cooling effect,
you had better employ the water tank drainage.
10mmMax