Replacement Part List

Warning!
Be sure to unplug the power before any
maintenance work!
Changing the Hydraulic oil .
(The quantity
of the hydraulic oil and
recommended type have been indicated
on page 5).
1. Make sure the LOG PUSHER (B in
Figure
1) is fully retracted.
2. Unscrew the DIP STICK (10) and
remove it together with O-type oil seal
(1l).(Figure
6)
3. Position a container under the Log
Splitter that will hold at least 4 liters
of
oiL Then tilt the machine to empty the
oil into the container.
4. Tilt the Log Splitter the other way, with
the Oil FilllDrain Port (in Figure 7) up.
Using a clean funnel,pour the Hydraulic
Oil into the hydraulic oil cylinder with
the volume specified at Page 4. (Be sure
to use only clean, high quality hydraulic
oil specifically made for this purpose.)
5. Clean the DIP STICK (10), and insert it
to make sure the oil level
is between the
two marks on the dipstick.
Warning!
Be
sure to dispose of the dirty oil
properly. Take
it to your local,waste
oil-recycling center. Never dispose
it on the
ground
or mix it with household rubbish.
6. Clean the DIPSTICK (10) and O-Type
SEAL (11) and re-install.
Be careful not
to damage the threads
of the aluminum
OIL CYLINDER COVER.
8