Replacement Part List

4. Position the log splitter securely and on
level ground or a secure stand.If necessary
block the wheels to prevent the log splitter
from moving during use.
solid supporting platform, 60-70cm high
without any objects on it. Which could
prevent complete freedom
of movement
for the operator while working. Never
operate the machine on the ground
because this may arise the risk
of the
injury to the face due to the splinter
or
rubbish and make the operation difficult.
Therefore we recommend using a special
Log Splitter platform.Ifnecessary.block
the wheels with wedges to prevent them
from rolling.
5. Open the Air Bleed (A in Figure 5).
Loosen the BLEED SCREW (14) 3-4
turns whenever the splitter is being used.
Retighten this screw when you are
finished.
6. Place log onto Splitter. lengthwise and
lying flat
on the Main Body
(l in Figure 1).The log
should lie flat on the Splitter. And
be
cradled by the Log Guiding Plates(A in
Figure 1).Never attempt to split a log at
an angle.Be sure the Wedge (J in Figure
1) and Log Pusher (B in Figure I) will
contact the log squarely on the ends.
7. Two hand operation. Depress the
Electric Motor
Stare Switch (Point F in
Figure
I) with one hand. Wait a few
seconds as the motor spins up and creates
pressure in the Hydraulic pump. Then.
when it is safe to do so. Depress the
Operating Handle (C in Figure I). The
Log
Pusher (B in Figure 1 )will compress
the log, pushing it against the Wedge
(J
in Figure I),Splitting the 10g.Once the
log is split, release both the Electric
Motor Stare Switch (F in Figure
I) and
the Operating Handle(C in Figure l):this
will allow the Log Pusher (B in Figure
I)
to retract.
Warning:
If the log does not split
Immediately ,do not force it
by
maintaining the thrust for more than a
few seconds.This can damage the tooL It
is better to try repositioning the log on
the splitter,or setting the log aside.
7
8. Stack as you work.This will provide a
safer work area. By keeping it
uncluttered. and avoid the danger
of
tripping. or damaging the power cable.
9. See point and question
5.
HOW TO FREE A JAMMED LOG
1. Release both controls,so that the LOG
PUSHER (Pos.B in Fig I) will be
fully retracted.
2.Insert a triangular
of wood under
the log.and activate log pusher to
push the wedge under the jammed log.
3.Repeat this process using.progressively
larger wedges. until the jammed log is
freed.
Warning:Never hammer on a jammed
log, or place your hands near the log
when attempting to free a jammed Jog.
'When attempting to free a jammed log, never
ask other people to tamper with the
machine.
• When the supporting feet is blocked,never
attempt to take it out by striking with a
tool. This may break the motor
assembly.
Sharpening the Wedge
I.After long periods
of operation,and .
when required; sharpen the wedge usmg
. a fine-toothed file and carefully.
Remove any burrs
or rough spots that
might have developed on the edge.