Replacement Part List

Put the main part on the foam material and
fix with 2 screws (21) and 2 nuts (20) and
tighten up
the supporting feet (19). (See
Figure 3)
On the main part that has been fixed on the
foam block with the supporting feet. Use
safety ring (59) to fix 2 wheels (60) onto
the shaft
of wheel frame (61). Then use the
wheel shaft cover (58) to cover the wheels.
Made sure that the wheels are not
obstructed and
turn uniformly. (See Figure
3)
Installation of operating ·handle
Take out the operating handles (54/55) from
the carton, and screw them onto the
receiving hole (52)
of the handles/ then
tighten up. (See Figure 4)
Now the Log Splitter
is ready for work
OPERATION
1. Plan your work site. Work safely and
save effort by planning your work before
hand. Have your logs positioned where
they can be easily reached. Have a site
located to stack the split wood or load
it
onto a nearby truck or other carrier.
2. Prepare the logs for splitting. This
splitter accommodates logs up to
520mm in length. When cutting large
sections,
do not cut sections any longer
than the specified length. Do not
attempt to split green logs. Dry,
seaconed Logs split much more easily.
and will not
jam as frequently as
green wood (moisture).
3. Route the power cable, and locate an
appropriate power outlet.
If required use
an adequate extension cable. Route the
cable from your power source in a safe
way, so that you avoid damaging the
cable during the working process and
persons tripping.
6