Use and Care Manual

M8 BOLT 53mm (X1)

M6 BOLT 50mm (X8)

M8 BOLT 60mm (X4)

(x4)

Nest Swing - BSW07

www.aleko.com

PAGE 1
www.aleko.
PAGE 2
Step 1. Insert tapered end of Top Bar 1 into the end of Top Bar 2. Make sure there is only 1 set of holes in the end connected to Top Bar 1. F5 16 16 Use 1 F2 fastener to connect Top Bar 1 to Top Bar 2 F5 **Always Make sure to place included washers between fastener head or nut and adjoining swing components** (x4) (x4) Step 2. Insert 1 Top Leg segment into either side of the T-shaped Connector, secure with 2 F3 fasteners per Leg. Repeat for both Connector and Top Leg assemblies. 7 7 Step 3.
PAGE 3
Nest Swing - BSW07 5 16 7 35 Anchoring the Gym to the Ground Step 1. Attach Ground Pegs to all 4 Nest Swing Bottom Legs using F6 fasteners. Step 2. Place assembled Swing Set in desired location and dig a footing hole, measuring 12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base of each support leg. Swing Set will be ready for use once concrete is fully set and cured (consult concrete manufacturer's instructions). Visit us at www.aleko.