Instructions / Assembly

Step 4 to Step 9

Repeat the Step 4-9 in P 13-14.

REV 12b

Step 3

With the gate in closed position and with the opener in their retracted position, place the opener with the

gate bracket and post bracket assembly on to the gate post and the gate. Position the gate bracket and

the post bracket assembly so that the gate opener is level with the horizontal cross member of the gate.

While holding the opener in the desired level position, temporarily secure with two C-clamps.

Step 10

The motors’ power wires and limit wires connection by

“Push to Open” is different from the connection by “Pull

to Open”. So motor 1 and motor 2 wires should be

connected to the control box as the instruction in the right,

not according to the instructions in Page 17.

The black wire should be inserted into the Motor+ terminal,

the red wire should be inserted into the Motor- terminal, the

yellow wire into ULT1 terminal, the blue wire into DLT1

terminal and the green wire is still into COM terminal.

Step 2

Attach the gate bracket and post bracket assembly to the

opener by inserting a clevis pin. Secure the clevis pins

using the hairpin clips.