Instructions / Assembly

`
13
Step 4
Determine the optimum position of the pivot bracket on the post bracket assembly by ensuring a
minimum 2.5cm (1 inch) distance exists between the gate and the gate opener in both the gate-open and
gate-closed positions. To ensure the minimum 2.5cm (1 inch) distance maintained in the gate-closed
position, remove the clevis pin from the gate bracket while holding the gate opener, and then close the
gate. Move the gate opener so as the gate bracket and the opener are aligned.
NOTE: Ensure the gate opener and the pivot brackets do not bind in the gate –open and gate –closed
positions.
If you don’t have enough distance, or the gate opener is binding on the post pivot bracket, you may move
the post pivot bracket assembly slightly to the right or left to obtain the proper distance.
After you’ve identified the desired position of the pivot bracket, place the M8 x 30 bolt into the desired
pivot on the post bracket.