Instructions / Assembly

Step 1

Place the post pivot bracket between the two post

brackets. Insert the M10 x 30 bolt through the center hole

of the post bracket and post pivot bracket as shown.

Place a ￠10 washer , ￠10 lock washer and M10 nut on

the bottom of the bolt and hand tighten.

REV 12a

Step 2

Attach the gate bracket and post bracket assembly to the opener by inserting a clevis pin. Secure the

clevis pins using the hairpin clips.

Step 3

With the gate in its desired open position (from 0° to 100° from the gate closed position) and with the

opener in its retracted position, place the opener with the gate bracket and post bracket assembly on the

gate post and the gate. Position the gate bracket and the post bracket assembly so that the gate opener

is level with the horizontal cross member of the gate. While holding the opener in the desired level

position, temporarily secure it with two C-clamps.

NOTE: There is an emergency release design. Use the triangular key to release the opener, you can

stretch the moving rod or retract it by hand to pull or push the front mount assembly. Be sure that the

openers are both locked before you prepare to activate your openers. Other information please

refer to content in page 24.