Instructions / Assembly

AC2000 SLIDING GATE OPERATOR

Magnets for limit switch (see Fig.7)

z Install the magnet as shown in Fig.7 below. The magnet and limit switch are used to control

the position of the gate.

z When the magnet is installed, release the gear clutch and push the sliding gate manually to

pre-determine the position. Fix the magnet bracket to the gate and then tighten the gear

clutch. The lower bracket is for open position and upper bracket is for close position.

Finally adjust the magnet to the proper position by moving the gate with the motor. The

magnet should be 10~15mm away from the magnetic limit switch. If it is too far away, the

switch will fail to work. Adjust the position of the magnet until the positions of the opening

and closing meet the requirement.

z Please note the position of two magnet brackets (fixed plate) are different: one is

upper and another is lower. Verify and if necessary exchange the two brackets

position. Also if necessary exchange the limit switch wires CL (close) and OP

(open).

Bracket

Gate

Magnetic limit

switch inside

Magnet

Magnet bracket

Gate operator

10-15mm

460mm

400mm

Plain washer

Spring washer

Bolt

Nut

Fig.7

6. Electrical

Make sure that the power is OFF before making any electrical connections. Perform the wiring.

(See control board scheme and wiring notes for control board)

Power

Using 18-3 gauge electrical wire, wire a standard grounded plug to your control board using

standard electricians wiring practices. Wire the opposite end of this cable to the E, N, L

contacts (block X1) of the control board. Connect L to the power line, N to the neutral line, and

E to the ground line.