Instructions / Assembly

AC2000 SLIDING GATE OPERATOR
Chain Brackets
Use the appropriate bolts to attach the chain bracket to the frame of the gate. If the gate is of
square frame style, use the square bolts shown.
Spring washer (Φ8)
Plain washer (
Φ8)
"L" bracket
Square bolt
Nut (M8)
Chain bolt
Master link
Nut (M6)
Spring washer (
Φ6)
Plain washer (
Φ6)
Gate
Square frame
Fig.4 Top view
If the gate is of round frame style, use the round bolts shown.
Round bolt
"L" bracket
Plain washer (
Ф8)
Spring washer (
Ф8)
Nut (M8)
Chain bolt
Master link
Nut (M6)
Spring washer (
Ф6)
Plain washer (
Ф6)
Gate
Round frame
Fig.5 Top view
Chain
Close the gate and attach a chain bolt to the chain using enclosure master links. Tighten the
chain bolt to the bracket with washers and nuts. Pull the chain through the sprockets to the
other chain bracket at the opposite end of the gate. Connect the other end of the chain and the
chain bolt, and then tighten the chain bolt to the chain bracket. Thread up the chain by
adjusting the chain bolt. Cut the chain to length if necessary. Tighten the chain by tightening
the chain bolts at either end. See Fig.6.
Master link
Chain bolt
Chain
Fig.6
7