Instructions / Assembly

AC2000 SLIDING GATE OPERATOR

Nut

Anchor

Gate operator

Wire

Anchor bolt

Conduit

Chain box

Socket head cap screw

Concrete pad

Operator bracket

Fig.2

Chain Box

Make sure the ends of the guide chain are out of the chain holes on both sides of the chain box.

Remove the cover and insert the manual release key and turn counter-clockwise to disengage

the clutch. Remove the elastic band from the shaft and line up the key on the shaft with the

sprocket at the chain box. Insert the sprocket from the chain box into the operator shaft.

Place the operator on top of the bracket and use (4) 5/8 “ (M8x15mm) socket head cap screws

to mount the chain box in to the bracket. See Fig.3

Operator

Mount the gate operator to the bracket using (4) 2 ¾ “ (M8x70mm) #48 bolts and washers.

Check the operator and make sure it is lined up with the gate.

Fig.3