DVM-120 observation system USER MANUAL
INDEX 2 1 INTRODUCTION........................................................................................ 3 2 2.1 2.2 FUNCTIONLIST BABY-UNIT................................................................................................. 3 PARENT-UNIT............................................................................................ 4 3 3.1 3.2 INSTALL BABY UNIT................................................................................................. 5 PARENT UNIT................
1 INTRODUCTION The Alecto DVM-120 is a wireless audio/video observation system, for indoor use. Either you can watch and listen to your baby continuously or you can choose to have the babymonitor been switched on when your baby starts to cry. 2 FUNCTIONLIST 2.1 BABY-UNIT: 1 6 ON 2 3 5 7 8 MIC OFF 4 9 10 1. 2. antenna light sensor, switches the infrared lighting on at dusk 3. camera lens 4. Infrared LED’s (for night view) 5.
11. night lamp 12. connection for the power adapter 13. built-in speaker 2.2 PARENT-UNIT: 1 TALK ON 3 AV 7 2 OFF 8 4 5 MIC 9 10 6 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
3 INSTALL 3.1 BABY UNIT: (CAMERA) The baby parent unit is not waterproof and therefore only suitable for indoor use. Power adapter: 1. Connect one of the supplied power adapters with de connector xx on the back of the baby unit. 2. Insert the adapter into a 230V outlet. Only use the supplied power adapter with modelnumber TGE050P055. Make sure the baby can not touch the baby unit or the cord.
3. Slide the battery cover back on the parent unit. Don’t force placing the battery. Only use the supplied rechargeable Li-ion battery (3.7V, 800mAh). Power adapter: 1. Connect the other power supply adapter with the connector on the side of the parent unit. 2. Connect the adapter to a 230V outlet. Only use the supplied power adapter with modelnumber TGE050P055. Make sure the power cable can not lead to stumble or fall.
4 USE 4.1 SWITCH ON / OFF: Baby unit: • Slide on the right side of the baby unit the switch to ON to switch on the baby unit. • Slide this switch to OFF to switch off the baby unit. Parent unit: • Slide on the right side of the parent unit the switch to ON to turn on the parent unit. • Slide this switch to OFF to switch off the baby unit. 4.2 PARENT UNIT: Reception volume: • Press repeatedly button to increase the receiver volume. • Press repeatedly button to decrease the receiver volume.
Night light on/off: • Hold button for over a second to turn on the night ligth on the baby unit. • Again hold button for over a second to turn off the night light. 4.3 MENU DRIVEN FUNCTIONS & SETTINGS: Press the parent unit on button to open the menu. At the bottom of the display the following icons apear. Select with the buttons and the desired function. volume of the talk back function of the baby unit: 1. push, after selecting the adjacent icon, the OK button to select this function 2.
Feeding timer: 1. push, after selecting the adjacent icon, the OK button to select this function 2. switch with buttons and to the ON function or OFF function 3. use the buttons and to select interval times (minimum 30 minutes, maximum 8 hours, 30 minutes adjustable) and press OK 4. push button 2x to capture the power timer and exit the menu The power timer sounds for 60 seconds max or push the OK button tot turn off prematurely.
Display temperature in °C of in °F: 1. push, after selecting the adjacent icon, the OK button to select this function 2. set with buttons and the desired display 3. press button 2x to capture the setting and exit the menu The DVM-120 only displays the temperature of the room where the baby unit is placed; you can not set alarm in here. Note that the temperature is displayed only indicative, you must consider a possible deviation of + or - 2 degrees. Multicamera: 1.
5 SYSTEM EXPANSION 5.1 GENERAL: The DVM-120 parent unit can log up to 4 cameras max. From the menu of the parent unit you can select the desired camera or you can display successively the images of all registered cameras (scan function). Expansion cameras are available through the Alecto service department on telephone 073 6411 355 (NL) , 03 238 5666 (B) of via www.alecto.nl 5.2 REGISTER ADDITIONAL CAMERAS: 1.
6.2 INSTALLATION: • Only connect the power adapter to the baby unit or the parent unit or disconnect when the power adapter is taken out of the wall outlet. • Don’t install the DVM-120 during an electrical storm. • Do not touch any uninsulated adapter cables unless the adapters have been taken from the wall outlet. 6.
6.6 INTERFERENCE-FREE: • This image baby monitor is digitally coded. So you will never receive the signal from other equipment nor will the signal of your baby unit (s) be displayed on the parent unit of, for example, your neighbors. • In case the baby unit (s) or parent unit is located in or in close proximity to electromagnetic fields, the signal can then (video or audio) experience some disturbance.
• • 7 Is this all okay, then take the adapters from the wall outlet, remove the rechargeable battery from the parent unit, now wait more than a minute and put everything back in place. Switch on the parent unit and the baby unit again. If you still have no video or sound, please contact the Alecto service department on telephone 073 6411 355 (Netherlands), 03 238 5666 (Belgium) or via internet www.alecto.
9 WARRANTY Alecto DVM-120 is guaranteed for 24 months from date of purchase. We guarantee during this period the free repair of defects caused by material and manufacturing defects. All this at the final judgment of the importer. HOW TO ACT: if you notice a defect, consult the manual first. If this manual gives you no definite answer, consult the supplier of the video baby monitor or the Alecto service department via www.alecto.info.
Service Help WWW.ALECTO.NL SERVICE@ALECTO.NL NL 073 6411 355 (Lokaal tarief) BE 03 238 5666 (Lokaal tarief) (Tarif local) DE 0180 503 0085 Lokale Festnetzkosten Hesdo, Australiëlaan 1 5232 BB, ‘s-Hertogenbosch The Netherlands Service WWW.ALECTO.NL SERVICE@ALECTO.NL NL 073 6411 355 (Lokaal tarief) (Lokaal tarief) Help BE 03 238 5666 (Tarif local) DE 0180 503 0085 (Lokale Festnetzkosten) Hesdo, Australiëlaan 1, 5232 BB, ‘s-Hertogenbosch, The Netherlands 16 v1.0 v2.
