Installation Instructions

Setup IntelliGaze™ Installation & Service Manual

4.5 Hardware Assembly /Std. VESA Adapter

During hardware installation, the camera and monitor will be combined into a stable module, which

may then be mounted on a monitor-arm or desk-stand.

This section explains the general principle of assembly, as the actual process may vary depending on

the selected monitor.

Standard TFT & CAM-30 VESA-Adapter

Required Tools: - Screwdriver depending on monitor-arm.

- 1,5 mm and 2 mm Allan/Hex keys (provide with the system).

The standard VESA adapter is implemented as a VESA-75&100 spacer. The adapter will be mounted

between a typical monitor's VESA-Interface and a monitor-arm. The adapter is 12mm thick, and the

screw-length should be selected accordingly.

Please make sure that longer screws do not damage the interior of your

monitor !

Version: 3.0

Monitor, top

VESA-Mount

Monitor-Arm

M4 Screws