User Manual

GB | Operating Instructions
12
8. Technical specications
Electric branch saw IEAS 750
Rated Voltage 230-240 V ~ / 50 Hz
Nominal Consumption 750 W
No-load Speed 6000 min
-1
Guide Bar 203 mm / 8“
Cutting length 185 mm
Variable height adjustment from 185 cm to 268 cm
Working height up to 4 m
Chain speed 11,2 m/s
Oil 90 ml
Weight with bar+chain 3,5 kg
Chain type ALP-50-33S/Kangxin
Guide Bar type AP08-33-507P/Kangxin
Class of Protection II
Sound Pressure Level L
pA
EN ISO 11680-1:2021
89 dB(A) K = 3 dB
Sound power level L
WA
104 dB(A) K = 3 dB
Vibration EN ISO 11680-1:2021 2,61 m/s
2
K = 1,5 m/s
2
Noise emission information in accordance with the German Product Safety Act (ProdSG) and the EC Machine Direc-
tive: The noise pressure level must be reduced depending on use and the tasks to be completed so that the health of
the operator is not impaired. The noise pressure level at the place of work can exceed 80 dB(A). In such cases the
operator will require noise protection (e.g. wearing of ear protectors).
Wear hearing protection. The inuence of noise can cause hearing loss.
Attention!
The vibration value will change on the basis of the area of application of the electric tool and may lie above the
specied value in exceptional situations.
Warning: The actual vibration emission value present during use of the machine may deviate from the values indica-
ted in the operating manual or by the manufacturer. In order to be exact, an appraisal of the level of strain for all work
phases during actual use must be considered, e.g. the times that the tool is switched o󰀨, idling, and during which it is
not in use. In this way, the level of strain may be reduced signicantly during the complete working period.
If the tool is regularly, you should wear anti-vibration gloves and avoid an ambient temperature of 10°C or lower while
working with it.
Create a work plan to spread the use of high-vibration tools across multiple days.
Ensure the lowest possible vibration of the device by completing regular maintenance and stable parts on the device.
Replace worn out components immediately.
The indicated vibration emission value has been measured according to a standardised testing process, and may be
used for a comparison with another electrical tool.
Attention: Noise protection! Please observe the local regulations when operating your device.