User Manual Great care has gone into the manufacture of this product and it should therefore provide you with years of good service when used properly. In the event of product failure within its intended use over the course of the first 3 years after date of purchase, we will remedy the problem as quickly as possible once it has been brought to our attention.
A 1 17 16 2 15 3 14 13 4 12 11 5 10 6 9 7 8 B 2 3 3b 3a 2 62 12 15 18
D C 1 2 1 3 3 2 F E 1 3 2 G 1 2 3 H ON OFF 3
Scope of delivery/device components Scope of delivery/device components 1 Handle grip (top) 2 Pull relief (for the power cable) 3 Quick-release lever (handle joint) 4 Bottom part of handle 5 Collecting bag 6 Connecting piece (2x) 7 Carry handle 8 Cutting height lever 9 Motor unit 10 Connection cable 11 Handle mount 12 Quick-release lever (handle mount) 13 Discharge flap 14 Fill level indicator 15 Cable clamps (2x) 16 Safety switch with power cable 17 Safety bar 18 Collecting bag handle 4
Table of content Table of content Overview..................................................................................................................2 Scope of delivery/device components................................................................... 4 General information................................................................................................6 Reading and storing the operating manual..................................................................6 Proper use.............
General information General information Reading and storing the operating manual This operating manual is part of the electric lawn mower (hereinafter also called "device"). It contains important information on how to set up and use the product. Before using the device, read the operating manual carefully, in particular the safety instructions. Failure to follow this operating manual may lead to severe injuries or product damage.
Explanation of symbols This symbol indicates that the device complies with the protection class II. General warning sign. Caution! Discharge of cuttings or stones. Always keep the discharge flap closed. Warning! Rotating blade! Do not reach or step underneath the device. Warning! Electric voltage. Read the operating manual. Keep other persons and animals out of the working range! Disconnect the device from the mains before carrying out maintenance and cleaning work.
Explanation of symbols Cutting width of the device. 96 IPX4 The symbol shows the maximum sound power level L . WA The device is protected from all sides against water splashes. Safety The following signal words are used in this operating manual. WARNING! This signal symbol/word denotes a hazard with an average risk level that could lead to death or severe injury if it is not avoided.
Safety - In the case of a fault, immediately disconnect the device from the power cable and/or mains. - Do not connect the device if the device, power cable or a mains plug shows visible signs of damage. - Damaged power cords and devices must only be repaired by the manufacturer, their customer service or a qualified professional. - Do not open the housing under any circumstances and never insert any object in the housing. - Always disconnect the device from the mains before cleaning or servicing it.
Safety older persons with reduced physical and mental capacities) or lack of experience and knowledge. Improper handling of the device can lead to severe injuries or damage to the device. - This lawn mower may be used by persons with impaired physical, sensory or mental capacities or those lacking experience and knowledge if they are supervised or have been instructed in how to safely use the lawn mower and have understood the risks associated with operating it. Children must not play with the lawn mower.
Safety - Do not work on areas with an inclination above 20 % as you might slip and lose control of the device. - Always keep the discharge flap closed and keep away from the discharge chute when working without a collecting bag. - Wait until the blade stands still before removing any blockage or clogging and carrying out any other work on the device.
Before first use 3. Place the bottom part of the handle on the handle mount 11 . Check whether the serrations of the locking washer engage correctly in the handle mount. The holes of the handle mount, the connecting pieces and the bottom part of the handle must point towards each other. 4. Twist the quick-release levers 12 all the way into the handle mount 11 . Do not use excessive force; it is sufficient to twist in the quick-release lever until you feel a resistance. 5. Flick the quick-release lever 12 .
Before first use 1. Insert the collecting bag handle 18 into the recesses on the top of the collecting bag 5 . 2. Pull the plastic rims of the collecting bag 5 from the inside over the steel frame. 3. Check whether the plastic rims are properly in place on all sides. 4. Completely lift the discharge flap 13 (see Fig. E right). 5. Hang the collecting bag 5 onto the hooks above the discharge chute again. 6. Check whether the collecting bag is properly fitted 5 . 7.
Operation - Always keep the discharge flap closed when mulching. Mow slowly and try not to use the entire cutting width to cut the grass evenly at high rotation speed. A high cutting load reduces the blade's rotation speed. Remove any branches, pegs, stones, strings and mounds (molehills) before mowing to safeguard the device. Always mow in the direction facing away from the power supply and the power cable. Always push the device forward; pulling the device might damage the power cable.
Operation Turning the motor on and off Caution! Blade keeps moving The motor is activated by means of a safety switch. When you let go of the safety bar, the motor stops. Only turn on the motor on the grass. 1. Place the device on the grass. 2. Press and hold the button of the safety switch 16 . 3. Pull the safety bar 17 towards the handle. The motor starts. 4. Let go of the safety switch button and keep the safety bar pressed to the handle as long as you operate the motor.
Cleaning Cleaning WARNING! Risk of electric shock! Moisture in the device may cause a short circuit or electric shock. - Before cleaning, disconnect the power cable from the socket. - Make sure that no water or other liquid gets inside the housing. - Never clean the device with running water (e.g. a garden hose). NOTE! Improper cleaning can damage the device.
Cleaning Do not operate the device with a damaged or worn blade! If necessary, have the blade sharpened or exchanged in a specialist workshop (for the blade type, see "Technical specifications"). 7. Set the device upright again. 8. Check all connections (handle, collecting bag) for tight fit. The device is ready for storage. Maintenance Apart from the measures described in the section "Cleaning and inspection after each use", the device is principally maintenance-free.
Storage Folding in the handle 1. Release the quick-release levers 12 on the handle mount 11 . 2. Take the serrations of the locking washer out of the handle mount 11 by lifting it slightly and then set down the handle on the device. 3. Release the quick-release levers 3 in the centre of the handle. 4. Carefully fold the handle. Watch out for the connection cable. It must not be pinched between the handle parts. The device is ready for storage.
Troubleshooting Troubleshooting Problem Possible cause Fault rectification Motor does not start up The mains plug is not correctly plugged in. Check that the mains plug is fitted properly. The socket does not supply any power/the fuse has blown or the RCCB has tripped. Check the power cable for damage. The button on the safety switch was not pushed. Let go of the safety bar and push the button on the safety switch before pulling the safety bar again.
Technical data Technical data Model GLM44A Rated voltage/frequency: 230–240 V~/50 Hz Rated power: 1800 W Protection class: II IP rating: IPX4 Max. rpm: 3500 min Weight (Net): 16.5 kg Dimensions (H x L x W) 1160 × 1180 × 475 mm Cutting width: 440 mm Mowing length setting: 20–70 mm -1 Guaranteed sound power level L : 96 dB(A) Sound power level L : Uncertainty K 93.04 dB(A) 1.2 dB(A) wA wA wA Sound pressure level L : Uncertainty K : 83.
Declaration of conformity Declaration of conformity Original EU Declara of Conformity We, MEROTEC GmbH O o-Brenner-Str. 8, 47877 Willich, Germany herewith declare under our own, sole responsibility that our product Electric lawnmower Model no. GLM44A complies with the following direc 2006/42/EC Machinery Direc 2014/30/EU EMC-Direc 2000/14/EC Outdoor Noise Direc , amended by 2005/88/EC conformity assessment procedure: 2000/14/EC Annex VI, no fied body No.
Disposal Disposal Disposing of packaging Dispose of packaging according to type. Sort the paperboard and cardboard as waste paper and the film as recyclable material. Dispose of old electrical device This symbol indicates that this product may not be disposed of together with domestic waste in compliance with the (2012/19/EU) Regulation pertaining to waste electrical and electronic devices (WEEE). This product must be handed in at a collection point intended for the purpose.
