Instruction Manual

11
AFTER SALES SUPPORT
YEAR WARRANTY
1
1300 663 907
AUS
[e-mail]
MODEL: AP180320 PRODUCT CODE: 709555 08/2022
.
.
Getting Started
Cutting Guide
Always inspect the appliance before use to ensure the clipper blades
are free from hair, debris etc. For best performance, use on clean, dry
hair that has been combed and is tangle-free
1. Select the desired attachment guide comb (numbered from 3 as
the shortest to 25 as the longest length) and place the groove
of the cutting guide onto the blades’ tip at the top of the Hair
Clipper (Fig 3). Firmly press the rear of the Attachment Comb
onto the end of the blade until it ‘clicks’ and locks into position
(Fig 4)
NOTE: You can adjust the height of the blade by pushing down the
Taper Lever
2. Place the cape around the neck of the person whose hair is
being trimmed or cut
TIP: This person should be seated so that the top of their head is at
your eye level
3. Comb the hair as it is normally styled, be sure to comb out all knots and tangles
4. Hold the Hair Clipper in the palm of one hand and with your thumb resting rmly on the top
of the Hair Clipper. This grip provides comfortable cutting control
NOTE: Although the Hair Clipper may be used left or right handed, using it right handed allows
you to access the taper lever more easily
TIP: Ensure the hair is dry. Hair Clippers perform best with dry hair, making it easier to see how
much hair is being cut
5. To remove Attachment Comb, ensure the Hair Clipper is switched off. Pull the release tab
on the rear of the Attachment Comb away from the blade and lift off
Taper Control
• The Taper Lever enables ne cut adjustment for precision clipping
• To increase the cutting length, push the lever down
• To reduce the cutting length, push the lever up
Tips for Cutting Hair
Step 1 – Nape of the neck
• Allow the clipper to cut through the hair without forcing it at a faster rate
• Use short strokes when cutting and initially use a long attachment comb. You can always use
a shorter attachment comb later if you want a closer cut.
• Use 3mm or 6mm guide comb
• Hold the Hair Clipper with the blade teeth pointing upwards. Begin at the centre of the head
at the base of the neck
• Slowly lift the Hair Clipper, work your way up and outwards through the hair,
trimming just a little at a time
3
4