Instruction Manual

10
AFTER SALES SUPPORT
YEAR WARRANTY
1
1300 663 907
AUS
[e-mail]
MODEL: AP180320 PRODUCT CODE: 709555 08/2022
.
.
Getting Started
Before Cutting Hair
Remove any packaging material and labels before using your Hair Clippers for the rst time.
Fully unwind the USB cord and inspect it for damage. Do not use the appliance if any part
has been damaged. In case of damage, contact our after-sales support line for advice on a
replacement or return.
Charging the Battery
• Before using your Hair Clipper for the rst time, charge it fully for 4 hours
• Plug the USB charging cord into your Hair Clippers and then plug the USB end into a USB
power source. Please ensure that the Hair Clippers ON/OFF switch is OFF. The charging
indicator light will glow red to indicate that it is charging and turns to green once fully charged
Optimising the Lifetime of the Rechargeable Batteries
Discharge the rechargeable batteries completely twice a year by
letting the motor run until it stops. Then fully recharge the batteries.
Changing the Combs
• Switch the clipper off before changing the combs
• To attach the combs, hold the comb with the teeth facing up and
snap it rmly to the bottom of the clipper blade (Fig 1)
WARNING! INJURIES & MATERIAL DAMAGE DUE TO INCORRECT HANDLING.
DO NOT USE THE APPLIANCE IF THE TEETH ARE DAMAGED OR MISSING FROM
THE BLADE OR IF THE BLADES ARE MISALIGNED AS INJURY MAY OCCUR
Lubricating the Blades
It is highly recommended before each use to lubricate the blades with the oil provided. This
ensures optimum cutting performance.
1. Plug the USB cord into a USB power adaptor and ensure it is switched ON
2. Use the oil supplied to lubricate the Hair Clipper. Unscrew the cap and cut off the tip of the
oil tube with a pair of scissors
3. Switch on the Hair Clipper, then gently squeeze the oil tube,
applying 2 drops onto the blades (Fig 2). Leave the Hair Clipper
switched ON for a further few seconds to allow the oil spread
thoroughly along the length of the blades. Then, switch OFF the
unit and remove any excess oil using a cloth
NOTE: To lubricate the blades, ensure the unit is switched ON.
2
1