Operating instructions

ALT5.INSA 070910-24

4) Loosen the two bolts that secure the ash lip to the  rebox

(Fig #23), carefully lift up the ash lip and remove from the

 rebox.

5) Loosen the screws on the wire support tabs and turn to remove

the wires (Fig #24).

6) Remove the two screws securing the speed controls assembly

to the ash lip (Fig #25).Remove cover plate on opposite

side.

Fan Speed Controller Relocation

The fan speed controller is factory installed under the ash lip

on the right hand side. If required, it can be relocated to the left

side by following the instructions below. To make this as easy

as possible, it is suggested that this be done prior to  tting the

surround and installation into the  replace:

1) Remove the decorative top by tilting up slighty and lifting

away from the unit. (Fig #19)

2) Lift up on each fan shield and remove. Set aside to prevent

damage. (Fig #20)

3) Disconnect the wires from the fans, Left & Right Side(Fig #21).

Unscrew thermal snap switch leaving the wires connected(Fig

#22). Take note of where the wires are routed and secured.

They must be positioned correctly to avoid damage.

BOLTS

SCREWS

Fig. # 19

Fig. # 20

Fig. # 21

Fig. # 23

Fig. # 25

Fig. # 24

FAN SHIELD

Fig. # 22

Lift Up