Operating instructions

ALT5.INSA 070910-24

8) Attach surround to  rebox by aligning with bracket studs (L)

then fasten with washers and nuts (M) on each side.

(Fig. #13)

9) Install fan shield as shown in Fig. #14. Be sure to place the

air inlet opening against the surround side.

10) Install the cast decorative top by tilting it at a slight angle,

sliding it under the surround top, and settling it over the fan

shields. (Fig #15).

11) Be sure to engage fan shield tops in the slots on the underside

of the cast decorative top. (Fig. #16)

Fig. # 17

Fan Removal/Installation

1) Remove Decorative Top and both Fan shields as speci ed in

“Fan Speed Control Relocation” section on page 11.

2) Disconnect fan wires as shown in Fig #17 from appropriate

fan that is being replaced. Remove Thermal switch if needed.

(Fig #18)

3) Remove the two screws securing the fan bracket to the stove

using a 7/16” socket or wrench. Reverse steps 1&2 to install

new fan.(Fig #18)

SCREWS

Fig. # 13

THERMAL

SWITCH

SLOT

AIR INLET

Fig. # 15

Fig. # 14

SURROUND

SIDE

Fig. # 16

Fig. # 18