Operation Manual

6
5:5 *FULLY AUTOMATIC CLIMATE CONTROL (ACC)
If you have a Truma AC installed and connected to the panel, then the AC button is visible and it is pos-
sible to control AC from the panel. This function makes it possible to have fully automated climate control
for both heating, cooling and hot water. The button is not visible if 230 V is connected from the AC.
1. Start LPG operation by pressing the LPG flame. The LPG symbol is
activated and changes colour to green.
2. The settings are now complete and the boiler will work at the set
temperature.
3. Press the LPG flame to switch o LPG operation, the symbol turns
blue.
1 kW
+22°C
1. Set the desired temperature.
2. Press the blue AC button,
the button turns green (see
fig. 2) and the AC function is
switched on, but is not neces-
sarily in operation. If gas and/
or electricity is switched on,
AC and the boiler work to
deliver the temperature set.
Regardless of whether heat
or cooling is needed in the
vehicle. To turn o the ACC
function, press the AC but-
3. To turn AC lighting o and
on, press the button rapidly.
When the button is kept
pressed in, the light changes
from dark to light and then
back (light to dark) and so
on in 10 brightness levels.
When the button is released
it stays at the current bright-
ness. This button is only vis-
ible when AC* is connected.
5:4 HEATING WITH GAS
Proceed as follows to activate heating with gas. The priority of electricity or gas can be set if both are
selected, see section 7:1 item 3.
1. Use the + or – button to switch on the electric heating and tog-
gle between the various power modes (O, 1 kW, 2 kW or 3 kW).
The set value will be displayed on the screen. The activated mode
is indicated by the + symbol changing colour to green. If a *load
monitor is installed and set, the boiler will not use more electricity
than it is capable of even if 3 kW is selected.
2. The settings are now complete and the boiler is working at the set
temperature.
3. To switch o electrical operation, browse down to O.
1 kW
+22°C
ton and it becomes blue. The
remote control for AC can be
used in this mode.
NB! Temperature sensors that
are used when full automatic
climate control is in operation
shall be positioned so that
they are influenced equally by
the heat from Alde’s heating
system and the air from AC. In
certain cases it can be an
advantage to us Alde’s temper-
ature sensor (Art. No. 3010 638).
1 kW
+22°C
Figure 1
1 kW
+22°C
Figure 2
1 kW
+22°C
Figure 3
5:3 HEATING WITH ELECTRICITY
Proceed as follows to activate heating with electricity. The more power (wattage) you select, the quicker
heating will take. A priority can be set when selecting both electricity and gas, see section 7:1 point 3.
The boiler does not use a higher output than is required, even if 3kW has been selected.
Functions marked with a (*) are accessories, which are not installed on all vehicles, refer to the vehicle
manufacturer’s instructions.