Operation Manual
11
GB
8. SERVICE MENU
The Service menu is accessed by pressing Service (see fig. 1). The function shows the values from the
boiler on the screen (fig. 2 and 3). The values are updated every second.
Settings
9. TROUBLESHOOTING
Always start by checking any error messages.
If a fault occurs in the system, the cause will be shown on the display. This is only displayed when the
control panel is in standby mode. To reset certain of the faults and restart, disconnect the panel from the
boiler, remove 230 V and disconnect 12 V from the boiler.
NB! The error messages can sometimes temporarily appear in connection with disconnection of 230 V or
12 V while the boiler is on. If there is no failure, these faults can be disregarded.
The boiler will not start on gas
• No LPG?
• Is the main tap fully open?
• Check that the type of LPG used is suitable for the prevailing outdoor temperature. Butane is unsuita-
ble for use at temperatures lower than +10°C. Use propane instead.
• If the boiler has not been operated for some time, or if the LPG cylinder is new, it may take longer
than normal to light the boiler.
• Check that power is being supplied to the boiler (> 11 V).
• Check that the fuse for the boiler has not blown.
• Check that the electrical connections on the boiler are secure and tight.
• If none of the above helps, contact a service workshop.
The electric element is not working
• Check that power is being supplied to the boiler (> 11 V). and (230 V).
• If none of the above helps, contact a service workshop.
• Check that the fuse for the boiler has not blown.
• If none of the above helps, contact a service workshop
*ACC not working
• Ensure that the temperature sensor that is used senses the heat from the boiler and the cooling from
the AC equally. If necessary, a more open temperature sensor can be used (Art. No. 3010 638).
Service
Water Temp: 55° C
Glycol Temp: 80° C
Fan rotation: 0RPM
Current: 0.0A
Overheat: Deact
Figure 1 Figure 2
Service
Ext Switch: deact
PCB Temp: 20° C
Boiler: XXXX
Panel: XXXX
Figure 3
Functions marked with a (*) are accessories, which are not installed on all vehicles, refer to the vehicle
manufacturer’s instructions.