Installation & Assembly

Step 3
Step 4
Next, place the chair onto the side of a table with the legs facing skywards.
Insert each front leg completely vertically into each seat frame corner.
PRESS FIRMLY DOWN with your hand until there is no gap.
Caution: Do not position the chair as shown in Picture 2, as it may
cause gaps.
Attach Front Legs using Bolt(a), Spring Washer(c) and Flat Washers(b) with
Allen Key(d).
Tighten the bottom Bolt first, then the top Bolt.
Caution: Tighten until secure and stable only, over tightening can cause
damage to the product.
If wobble
Test again
30CM~50CM
5 OF 7