Caution: You must read this before you proceed.
Label Description QTY A Chair Back 1PC B Chair Seat 1PC C Front Legs 2PCS Description QTY a Dia.
Before Beginning Assembly: Unpack all the parts for a clear overview. Pack A for locking the back panel of the seat to the horizontal panel of the backrest: Five Dia.M8 Bolts:60mm(a)+five Flat Washers(b)+ five Spring Washers(c) Pack B for Locking the Front Legs to the front corner blocks of the seat:Four Dia.
Step 1 Chair Back Chair Seat Place the Chair Back(A) on a clean, non-marring surface. Take out the two Wooden Legs and the package of Hardware accessories. Step 2 Put the Chair Back(A) onto a clean and flat table or surface. Align the positioning dowels on the Chair Seat(B) with the mounting position located on the Chair Back(A). Use your left hand to push the seat frame floorwards, depicted by Arrow 1.
Step 3 Next, place the chair onto the side of a table with the legs facing skywards. Insert each front leg completely vertically into each seat frame corner. PRESS FIRMLY DOWN with your hand until there is no gap. Caution: Do not position the chair as shown in Picture 2, as it may cause gaps. Attach Front Legs using Bolt(a), Spring Washer(c) and Flat Washers(b) with Allen Key(d). Tighten the bottom Bolt first, then the top Bolt.
Place the chair on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the chair 30cm to 50cm from the ground. Keep your feet and toes well away from the drop zone. Drop the chair freely and vertically with the four legs hitting the ground at the same time. This Drop Test will help to ensure that all the bolts and gaps reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobble is found, proceed to tighten all the bolts.
OF 7
