Installation & Assembly

Assembly Instructions 4/4
Slider Wheel
I2
I3
I4
I1
I1
Figure 1
Line up Side Parts (I3) and (I4) to the
Front Part (I1) and Back Part (I2). Make sure
the sign on each part is going down.
Using a Philips screwdriver, insert 1” screws
into each of the 4 pre-drilled holes on the
sides (I3) and (I4), then tighten half way.
Drawer
Part List
I1.
Front Part
2 pcs.
I5.
Bottom Part
2 pcs.
I2.
Back Part
2 pcs.
Figure 2
Figure 3
Turn the assembled drawer over and slide the
Plywood Bottom Part (I5) into the grooves
of Side Parts (I3) and (I4). Be sure to push
the plywood bottom part all the way forward,
so it meets the Front Part (I1).
Insert the remaining ½” screws (6 pcs.)
into the pre-drilled holes at the Bottom Part
(I5), then tighten up all screws
I4
I2
I5
I1
I3
I3.
Side Part
2 pcs.
I4.
Side Part
2 pcs.
Assemble the Pull Handle
to the Front Part (I1)
with Machine Screw.
* If you are missing any of these
parts, please contact our DMI
Customer Service Department
at 1-877-831-0319 or fax us at
1-800-755-2878.