Installation & Assembly

ManualsBrandsAlcott Hill ManualsFurnitureEwart Kitchen Island with Wood Top

Part List

Hardware List

Side Frame

1 pc.

Top

1 pc.

Hex Wrench

1 pc.

Caster

Two casters with lock

Two casters without lock

4 pcs.

Machine Screw

for Pull Handle

4 pcs.

Pull Handle

2 pc.

Head Cap Bolt

19 pcs. (+1Extra)

Wood Screw

Short 6 x ½”

(for Drawer Bottom Part)

12 pcs.(+1 Extra)

Wood Plug

13 pcs.

(+1 Extra)

Wood Screw

Long 6 x 1”

(for Drawer Side Part)

16 pcs.(+1 Extra)

Tools Required For Assembly : Philips screwdriver

Attention!

Our customers will always get the perfect products,

if they strictly follow the assembly instructions.

Thank you for purchasing our quality products.

Front Rail

2 pcs.

Back Rail

1 pc.

Divider

1 pc.

Shelf

1 pc.

Drawer

(Knock-Down Construction, please refer to

the page (4/4) of these instructions for

steps to complete assembling drawers)

2 drawers

Side Frame

1 pc.

Head Cap Bolt (short)

(for Side Bar)

2 pcs. (+1 Extra)

Base

1 pc.

Side Bar

1 pc.

88521695 C

Solid Wood Top Kitchen Island

Supporting Pin

4 pcs. (+1 Extra)

Summary of content (4 pages)

PAGE 1
88521695 C Solid Wood Top Kitchen Island Attention! Our customers will always get the perfect products, if they strictly follow the assembly instructions. Thank you for purchasing our quality products. Part List A. Top 1 pc. B. Side Frame 1 pc. E. Back Rail 1 pc. C. Side Frame 1 pc. G. Base 1 pc. D. Front Rail 2 pcs. H. Shelf 1 pc. I. Drawer (Knock-Down Construction, please refer to the page (4/4) of these instructions for steps to complete assembling drawers) 2 drawers F. Divider 1 pc. J.
PAGE 2
Assembly Instructions 2/4 IMPORTANT Do not tighten up all the screws until each part is properly assembled. You should keep Hex Wrench in the safe place as you may need to tighten up the Head Cap Bolts in the future. Non-Locking Caster STEP 1 Turn the Side Frame (B) upside down on the soft material. Locking Caster Attach the locking caster to the leg with sign, and the non-locking caster to the other leg. B Do the same for the Side Frame (C).
PAGE 3
Assembly Instructions 3/4 Head Cap Bolt STEP 4 C Attach the Base (G) and Side Frame (C) to the assembled unit. G Head Cap Bolt Head Cap Bolt (short) C Head Cap Bolt STEP 5 J Attach the Side Bar (J) to the Side Frame (C). Head Cap Bolt A STEP 6 Place the Top (A) on the assembled unit. Insert the Supporting Pins into both side frames at the desired level. Place Shelf (H) and slide the Drawers (I) into place.
PAGE 4
Assembly Instructions 4/4 Drawer Slider Wheel I1 I4 Figure 1 I3 Line up Side Parts (I3) and (I4) to the Front Part (I1) and Back Part (I2). Make sure the sign on each part is going down. Using a Philips screwdriver, insert 1” screws into each of the 4 pre-drilled holes on the sides (I3) and (I4), then tighten half way. I2 Figure 2 Turn the assembled drawer over and slide the Plywood Bottom Part (I5) into the grooves of Side Parts (I3) and (I4).