Assembly Instructions

IMPORTANT
* Do not tighten up all the screws and bolts until each part is properly assembled.
* You should keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Use a soft cloth between these parts and the fl oor.
STEP 1
Attach Front Rails (D) and Back Rail (E) to Divider (F) with
Head Cap Bolts (long). (See Figure 1)
Figure 2
Assembly Instruction 2 / 4
D
Head Cap Bolt (long)
STEP 2
Attach Side Frames (B) and (C) to
the unit from Step 2 and Base (G)
with Head Cap Bolts (long).
Attach 4X Casters to unit with
locking casters at the front and
non-locking casters at the back.
(See Figure 2)
C
G
B
Head Cap Bolt (long)
D
F
E
Locking Casters
Non-Locking Casters
Figure 1