Manualshelf

User`s guide

ManualsBrandsAlcorn Mcbride ManualsDocking StationInformation Station
81828384858687888990
INI File – is.ini 77
INI File
INI File – is.ini
In the MEDIA folder (where you are located by default when you log in via FTP) is is.ini. It has INI
settings that you can use to setup default behavior of the unit. Here are the entries and descriptions.
Many of these are changed automatically when you send a command to change them via the interfaces.
Or you can edit it manually and FTP it to the unit then reboot for the settings to take effect.
[GEOGRAPHICAL]
Longitude=0 set this if you want sunrise sunset calculations for scheduler to work
Latitude=0 set this if you want sunrise sunset calculations for scheduler to work
TimeZone=5 set this when you set your time
DSTEnable=1 set this to support Daylight Savings Time
DSTType=usa set this to values like usa, aus, utc. Check the General Command table for values
[GENERAL]
UnitID=1 unit ID – useful when talking to multiple units over UDP and serial
UpdateINI=1 Set to zero to turn off changes to your INI – rarely used.
DontSendSerialResponses=1 Acks and Nacks are NOT sent out serial port. Used when unit is
controlling another product that would get confused from those messages.
[SCHEDULER]
BootUpDelay=0 Make the scheduler wait this many seconds before beginning.
LogActivity=0 Set to 1 to Log scheduler activity
Verbose=1 Set to 1 to Log scheduler engine activity in heavy detail – good for debug
[NETWORK]
IPAddress=192.168.0.254
SubnetMask=255.255.255.0
GWAddress=192.168.0.1 Gateway Address
DNS1=12.12.12.12 Domain Name Server Primary Address
DNS2=12.12.12.12 Domain Name Server Secondary Address
Password=password FTP login password
[VIDEO]
MuteAudio=0 Set to 1 to mute the video’ s audio track
Format=NTSC Set to PAL, NTSC, or MONITOR depending on your preference
Volume=1000 Set the volume. This is in milli decibels (later may change to percentage)
Balance=0 Set Left/Right balance. 0=middle, -10000=all left , 10000 = all right side
[AUDIO]
Mute=0 Set to 1 to mute the separate audio channel
Volume=1000 Set the volume. This is in milli decibels (later may change to percentage)