User`s guide

16 Rear Panel
Note: All protocol connectors on the DVM2 are internally combined into one
port. Selecting a new protocol effectively causes all connectors to listen for that
protocol, therefore, only one device should be communicating through these
connectors at a time.
¾Password Reset
This switch allows you to reset the User Name, Password, and IP address of
your DVM2 to their default values in the event that they are lost. This
functionality is discussed further in the section entitled Forgotten Password or
IP Address. When the switch is “ Off”, the DVM2 will operate with its set
parameters. When the switch is “ On”, the DVM2 will reset itself to the default
IP Address, User Name and Password.
¾Video Select (DVM2 only)
These switches determines whether the DVM2’ s S-Video component video (Y-
C) output is active, or the RGB (VGA) output is active. Regardless of the setting
of this switch, both of the DVM2’ s composite video outputs are always active.
Switch 7 Switch 8 Mode
Off Off Setup via Web Page (or .ini file)
Off On YUV active through HDB15 connector
On Off RGB active through HDB15 connector
On On S-Video active