User`s guide

DVM4.INI 63
DVM4.INI
In the MEDIA folder (where you are located by default when you log in via FTP) is located
DVM4.INI. It contains settings that you can use to setup default behavior of the unit on power-up.
Below, you will find an example of this file containing all of the entries and descriptions. All of these
are changed automatically when you send a command to change them via the remote control
interfaces. However, if you wish, you may edit DVM4.INI manually and reboot the unit for the
settings to take effect.
[GENERAL]
UnitID=1 unit ID – useful when talking to multiple units over UDP broadcast
GroupMode=PEER Grouping Mode – Sets behavior of grouped channels - * see next page
[GEOGRAPHICAL]
Longitude=81 set this if you want sunrise sunset calculations for scheduler to work
Latitude=28 set this if you want sunrise sunset calculations for scheduler to work
TimeZone=-5 set this when you set your time
DSTEnable=1 set this to support Daylight Savings Time
DSTType=usa set this to values like usa, aus, utc. Check UDP table for values
[SCHEDULER]
BootUpDelay=0 Make the scheduler wait this many seconds before beginning.
LogActivity=No Set to 1 to Log scheduler activity
[NETWORK]
IPAddress=192.168.0.254
SubnetMask=255.255.255.0
GWAddress=192.168.0.1 Gateway Address
Password=password FTP login password
[CHANNEL1]
VideoMode=NTSC NTSC, PAL, 720p, 1080i, 480i, 480p, 576i, 576p
Colorspace=Composite Composite, RGB, YUV
Aspect=4:3NORMAL 4:3 Aspect Ratio **see next page
[CHANNEL2]
VideoMode=NTSC
Colorspace=Composite
Aspect=4:3NORMAL
[ETC…]