User`s manual

Alcorn McBride Binloop User’s Manual Page 82
MIDI Out
The MIDI Out connector repeats any input received through the MIDI In
connector. For more information on the MIDI control and Timecode
control interfaces, please refer to the Controlling the Binloop section of
this manual.
Pin Signal
1 N/C
2 GND
3 N/C
4 MIDI Out -
5 MIDI Out +
V-Sync
The V-Sync connector is a female BNC connector that is designed to
accept a blackburst video sync signal. When a sync signal is applied to
this connector, the A/V system of the Binloop will use this as a reference
for all audio and video generated within the Binloop. For more details
about using external video sync with the Binloop, refer to the A/V Sync
System chapter in the About the Binloop section of this manual.
SMPTE
The SMPTE connector provides both an input and output for the SMPTE
interface of the Binloop. The balanced input is 600 ohm transformer-
isolated and will accept levels between 1- 5 Vpp. The balanced output
level defaults to 0dBV into 150 ohms, but can be adjusted between 0-
4dBV using the front-panel menu of the Binloop. For backward
compatibility with previous Binloop systems, an alternate V-Sync input is
also provided on this connector.
Pin Signal
1 SMPTEIN +
2 SMPTEIN -
3 N/C
4 VSYNCIN
5 GND
6 N/C
7 N/C
8 SMPTEOUT-
9 SMPTEOUT+