User`s manual

Alcorn McBride Binloop User’s Manual Page 50
If you intend to communicate with RS-232, you must select the Serial
option and specify the COM port in your PC that is connected with the
Binloop. If you are using Ethernet, you must select Ethernet as the
communication method and then enter the Binloop’s IP address in the
provided box. Once you have setup the appropriate connection, click the
OK button to close this window.
To make sure that the connection is working properly, click on the
icon at the top of the Binloop window. This will open the Unit
Configuration window you see below.
Click on the Detect button. If the connection is working properly, the
Version box will display the current version of the Binloop’s controller
card. If this is not the case, please refer to the Troubleshooting Guide
for assistance.