User`s manual

Alcorn McBride Binloop User’s Manual Page 33
Search Clip
Description: This command causes the Binloop to preload the specified clip. If it is a video
clip, the reproducer(s) will pause on the first frame of the video. After this
happens, the next Play command causes the clip to start playing.
Command: nnnnaaaSE
Parameters: nnnn is an ASCII file number between 0-1023
aaa is the address of the card(s) you want to process the command
Rxx – Reproducer address between R1-R16
Gxx – Group address between G1-G13
* - Wildcard address for all reproducers
Response: R
Examples: Search File 1 on Reproducer #2: 1R2SE
Search File 2 on Group #1: 2G1SE
Search File 52 on All Reproducers: 52*SE
Play / Resume
Description: This command will start playing a clip that was previously loaded by a Search
Clip command. This command will also resume playback when the reproducer
has been stilled or paused.
Command: aaaPL
Parameters: aaa is the address of the card(s) you want to process the command
Rxx – Reproducer address between R1-R16
Gxx – Group address between G1-G13
* - Wildcard address for all reproducers
Response: R
Example: Search File 1 on Reproducer #2: 1R2SE
Play pre-searched file R2PL
Loop / Resume
Description: This command functions just like the Play / Resume command except that the
video loops once the end of the clip is reached.
Command: aaaLP
Parameters: aaa is the address of the card(s) you want to process the command
Rxx – Reproducer address between R1-R16
Gxx – Group address between G1-G13
* - Wildcard address for all reproducers
Response: R
Example: Search File 1 on Reproducer #2: 1R2SE
Loop pre-searched file: R2LP