User`s manual

Alcorn McBride Binloop User’s Manual Page 30
Get/Set SMPTE Loop Mode
Description: This command will get or set the current SMPTE loop mode.
Parameters: x = mode number:
0 = SMPTE looping is Disabled on power up
1 = SMPTE looping is Enabled on power up
Get Command: LM
Response: x
Example: Command: LM
Response: 1
Set Command: xLM
Response: R
Example: Command: 1LM
Response: R
Get/Set SMPTE Powerup Mode
Description: This command will get or set the current SMPTE power up mode.
Parameters: x = mode number:
0 = SMPTE Disabled on power up
1 = SMPTE Enabled on power up
Get Command: PM
Response: x
Example: Command: PM
Response: 1
Set Command: xPM
Response: R
Example: Command: 1PM
Response: R